Tatung TLM TLM-1705 Bedienungsanleitung

OPERATING INSTRUCTIONS TLM-1705 / TLM1905

4Raising Your Monitor to an Upright Position and Adjusting Monitor Angle

5 Power Management System The LCD multimedia monitor complies with the VESA DPMS power management proposal. When the LCD multimedia monitor is in p

6 CHAPTER 2 The Display Controls LCD Multimedia Monitor Control Panel Figure 2-1: The LCD Monitor Panel 1. OSD Menu Button Press this button to po

7Adjusting the Monitor’s Display OSD Main Menu To access the OSD main menu, press the OSD Menu button. Use the Function Select buttons to scroll be

8 H-POSITION: To move the LCD monitor’s display left or right on a horizontal plane. V-POSITION: To move the LCD monitor’s display up or down on

9 EXIT: To exit the OSD-Control submenu. GRAPHIC-CONTROL Option The Graphic-Control option lets you make adjustments that effect the contrast, br

10 Press the Adjustment control button to display the submenu. LANGUAGE: The supported languages include German, English, French, Spanish, Italian

11OSD-CONTROL Option The OSD-Control menu option lets you adjust the position of the OSD on the screen. Press the Adjustment control button to displ

12MISC-CONTROL Option The Misc-Control menu option lets you select the OSD display language, adjust the audio volume setting and view system informa

13 EXIT: To exits the Monitor-Control submenu. OSD-CONTROL Option The OSD-Control menu option lets you adjust the position of the OSD on the scree

14 SATURATION: To adjust the color level you prefer. SHARPNESS: Press the adjustment button to optimize the sharpness for your specific applicat

15 Note: 1. No Video When the monitor is ON and there is no Video signal received, the following message will be displayed. 2. Signal out of monit

16Hot-Key Buttons for Quick Adjustment of Monitor Settings. (〝AUTO-ADJUST〞hot-key is effective only when analog input signal is selected for applica

17 APPENDIX A Troubleshooting Troubleshooting Procedures This LCD monitor comes pre-adjusted with standard VGA timing. Due to output timing differen

182. Turn off the LCD monitor and then turn it back on again. Press the OSD Menu button (refer to Chapter 2) once and then press either Adjustment

19APPENDIX B Technical Information LCD Monitor Specifications LCD Panel 17-inchTFT Control Functions Power Software switch with LED indicator (t

20 Display Area 337.920 mm x 270.336 mm (17.0-inch diagonal) Display Colors 16M Video Input VGA, DVI (Optional), S-Video, AV Scanning Freq

21APPENDIX C Supported Timing Item Standards ResolutionDot Clock (MHz) Vertical Scanning Frequency(Hz) HorizontalScanning Frequency (kHz) Sync Po

6200564280 TATUNG COMPANY OF AMERICA 2850 El Presidio ST. Long Beach, CA 90810 (800) 827-2850 www.tatungusa.com

i PREFACE FCC Compliance Statement This device complies with part 15 of the FCC Rules. Opeartion is subjected to the following two conditions: 1. T

ii The Federal Communications Commission warns that changes or modifications of the unit not expressly approved by the party responsible for complianc

iii Important Operating Instructions Please read the following instructions carefully. This manual should be retained for future use. 1. To clean

iv Introduction CONTENTS PREFACE ...

1 CHAPTER 1 The LCD Multimedia Monitor Unpacking After you unpack your LCD multimedia monitor, make sure the following items are included in the box

2Identifying Components The LCD Multimedia Monitor — Front View Figure 1-1: The LCD multimedia Monitor Front View 1. Power-On Indicator This LED i

3 1. Audio Line-in 2. AC Power Jack 3. VGA (Analog) Cable With 15-Pin D-Sub VGA Connector (Male) 4. S-Video connector 5. AV connector 6. Digital